Atwood Levelegs 5th Wheel Leveling IOM Manual de usuario

- 1 - Table of Contents Installation 2-10 Leveler legs………………………………………………………...……… 2 Controller………………………………………………………………... 4 Di

- 10 -

- 11 - LEDs in all images will be represented in this format: Before operating the levelers, you must do the follo

- 12 - CONTROL BOARD INSTALLATION AND OPERATION TO SET HOME POSITION (ALL JACKS FULLY RETRACTED) • If all Leveler lights are blinking

- 13 - TO SET AUTO POSITION (DEFINE LEVEL) NOTE: This same process can be used to reprogram AUTO position. Set Home Position as described above before

- 14 - UNHOOKING FROM TOW VEHICLE AND LEVELING RV NOTE: If any button is pressed during an auto sequence, the levelers will stop. The controller will

- 15 - If the home position has not been programmed or while in error mode and all levelers are retracted; 1. Switch Activation Switch to ON and Pres

- 16 - SYSTEM PROTECTION FEATURES Nine Cycle Maximum • The controls will shut off for about 15 minutes any time nine (9) RET ALL commands are complete

- 17 - 1. Internal parts of leveler are permanently lubricated at the factory and do not require any further lubrication. 2. If it is not possible

- 18 - This guide is only intended for use on Atwood products by service technicians who have successfully completed Atwood training. This guide shou

- 19 - LEVELER CONTINUES TO “CLUTCH” • Leveler replaced or operated separate from control pad (manually operating nut / drive shaft or supplying dire

- 2 - LEVELER LEGS 1. Install direct drive levelers as close to the front bulkhead, and the rear levelers as close to the rear w

- 20 - LEVELERS WILL NOT MOVE • No power or signal to levelers 1. Check the circuit breaker and reset if necessary. 2. Insure the Activation Switc

- 21 - PANEL LIGHTS BLINK “ON” AND “OFF” • An Auto Position is not set Set the Auto Position, referring to page 13. FALSE RET (FULL RETRACTION) ERR

- 22 -

- 3 - 2. Position leveler vertically against frame so base of foot has 8-9" minimum ground clearance when RV is loaded to its maximum GVWR (NOTE

- 4 -

- 5 - Dip Switch Configuration • In order to accommodate as many units as possible, there is a set of four small “dip switches” on the control board

- 6 - Controller Location 1. To optimize the effectiveness of the Controller, it should be mounted as close to the center of the RV as possible. The

- 7 - CONTROLLER WIRING All information below pertains to the diagram on the page 10 NOTE: Atwood recommends using the Plug n’ Play harness kit • If

- 8 - control pad. Signal Wire Harness / Activation Switch NOTE: It is important for this harness to be plugged in after all other wir

- 9 - Leveler Power Connections • Use the 10 AWG connectors (red and yellow wire) to connect the leveler motors to the control Board. NOTE: Wires ca