Atwood EDWIN RV Entry Door Window Manual de usuario descargar pdf

EDWIN Installation Guide

Installing the Entry Door Window (a.k.a. EDWIN) in your RV is easier than you might

think. First timers should plan on 30-45 minutes to complete the EDWIN installation.

To make this as easy as possible, we have provided step-by-step instructions for this

Do-it-yourself project.

Tools needed. Your new Atwood EDWIN window is shipped with

all the parts you need for a complete installation: Window and

Frame, Interior Trim Ring, Screws and Flange Seal Tape. The only

tool you will need is a Screw Gun and Putty Knife.

Step 1. Remove the old door window.

•

Remove all the screws around the perimeter of the old

door window frame from inside the vehicle. There will be

approximately 16 screws . (See photo A)

•

Once all screws are removed, the inner trim ring can be set

aside and the window can now be pushed out of its open-

ing (See photo B). It is recommended that a second person

stand outside with a hand lightly on the window to pre-

vent the window from falling to the ground.

•

If the window is still firmly in place after all screws are re-

moved, you can break the seal by sliding a thin putty knife

under the exterior of the window flange and work your

way around the window until loose. (See photo C)

•

Once the old window is successfully removed, carefully re-

move any remaining sealant or tape that is stuck to the

outside wall at the window opening.

1 2

EDWIN Installation Guide Installing the Entry Door Window (a.k.a. EDWIN) in your RV is easier than you might think. First timers should plan on 30-45

Step 2. Verify window fit. • First you will need to remove the 4 short packaging screws holding the window and trim ring together. These are for s

Sin comentarios

Atwood EDWIN RV Entry Door Window Manual de usuario